
Gurgling or wet bubbling sounds can occur when air passes through excess liquid or condensation in the airflow channel. Light crackling when the liquid is heated is a different sound and may be normal.
What can cause the gurgling?
- Overfilling: too much liquid or liquid in the airflow channel can carry liquid into the airpath.
- Condensation: liquid can collect in the mouthpiece and accessible airflow paths, even after a period of non-use.
- Overfeeding: excess liquid during priming, an incorrectly installed coil or overly thin liquid can provide more liquid than the design can handle. The coil’s wick should, however, be thoroughly saturated.
- Leaks: an unsecured fill port, damaged seal or incorrectly installed coil can allow liquid into the airflow channel or out of the tank.
What should I do about liquid in the airpath?
Turn off the device and let it cool before handling. Do not try to clear the liquid by taking longer or harder draws.
- Dry it: only remove the intended parts and dry the accessible mouthpiece and removable surfaces with dry paper towel. Do not insert paper into the coil’s cotton or the electronics.
- Empty if necessary: a refillable tank can be emptied through the intended opening. Sealed pre-filled pods and disposable vapes should not be opened for emptying or cleaning.
- Correct the filling: use the fill opening, never the central airflow channel. On the Joyetech eGo AIO, the MAX marking must not be exceeded. On the GoMax, close the airflow ports during filling and open them again afterward.
- Check seals and assembly: removable O-rings should be intact, seated in their grooves and not pinched. Assemble straight without forcing threads or overtightening. Replace a damaged seal or sealed pod.
Our guide to a leaking e-cigarette tank describes more filling and sealing problems. Do not use the device with the airflow completely closed. Stop if liquid reaches your mouth or the leak continues. Suspected liquid in the electronics requires stopping both use and charging.
Does the coil need to be cleaned or replaced?
A wet wick does not need to be replaced solely because it is thoroughly saturated. A pre-made coil with cotton should not be rinsed as a general cleaning method. Stop if there is a burnt taste; burnt cotton cannot be restored through cleaning or refilling.
Replace a damaged or worn-out replaceable coil separately. With a built-in coil, replace the pod or, for the Innokin GoMax, the entire tank. How to replace the coil explains the differences. Gurgling alone does not determine whether replacement is needed.
How is a new coil prepared?
For the Innokin Go-Z, the manufacturer states that the cotton in the new wick should be moistened with e-liquid before the tank is filled and left to stand for at least five minutes. Avoid excess liquid in the airflow channel.
What affects liquid feeding?
PG is more fluid than VG. Liquid that is too thin can overfeed a design; liquid that is too thick can feed too slowly. Innokin specifies 50VG/50PG or 70VG/30PG for the Go-Z and 70 percent VG or more for the GoMax. The explanation of VG and PG describes the properties of the bases.
Store the tank or pod upright. Keep the mouthpiece, removable pod contacts and other accessible surfaces clean and dry. Close the fill port and install the coil and pod without pinching the seals. Persistent problems require troubleshooting; contact our support team without opening the electronics.
Quick Facts
- Reading Time
- 3 min
- Popularity
- Very Popular
- Category
- Troubleshooting & maintenance
- Published
- 2025-05-22
Related Products
Products mentioned in this article





