
A dry hit is dry heating: the coil heats a wick that has too little e-liquid. This can produce a burnt or stinging taste. Stop using it if there is a burnt taste; burnt cotton needs to be replaced.
Why does a dry hit occur?
The wick should carry liquid to the heating element in an e-cigarette. If more liquid evaporates than the wick can supply in time, the supply becomes insufficient, even with a new coil.
- Low liquid level: the wick can become dry if the level drops below the coil’s liquid openings.
- Too high power: the liquid may evaporate faster than it is supplied.
- Insufficient preparation: a new wick needs to become thoroughly saturated before activation.
- Too viscous liquid: some coils have openings and a wick that feed a VG-rich liquid too slowly.
- Wear and deposits: the supply may deteriorate as the coil is used.
How is the liquid level maintained?
In a refillable container, the liquid should be kept above the coil’s liquid openings and below the maximum mark. Fill through the designated opening. A sealed pre-filled pod should not be opened for refilling.
How is a new coil prepared?
For Innokin Ajax, the manufacturer specifies one drop of e-liquid on each visible cotton opening on the side of the coil. Do not drip into the central airflow channel. Install the coil, fill the tank and wait at least five minutes.
Direct wetting requires accessible cotton openings on a designated replaceable coil. Do not open a sealed pod to access the wick. The guide on how to replace a coil describes the replacement designs.
What power should be used?
With manual wattage selection, keep the power within the current coil’s range. Start at the lower limit when a new coil has been thoroughly saturated. For the Innokin Ajax 0.35 ohm, the range is 30–55 W and the lower limit is 30 W.
A device without manual wattage selection is not adjusted in the same way. Higher power does not solve slow liquid feeding. If there is a burnt taste, stop using it instead of continuing to try different wattage settings.
What significance does VG/PG have?
PG, propylene glycol, is more fluid than VG, vegetable glycerin. The liquid’s viscosity needs to suit the coil’s openings and wick.
50VG/50PG means equal parts VG and PG. For Vaporesso COSS, the manufacturer specifies PG/VG 50:50 or a higher proportion of PG. The size of the device or the coil’s ohm rating alone does not determine the mixture. Our guide to VG and PG explains the properties.
When should a coil be replaced?
Burnt cotton cannot be restored through cleaning or refilling. Replace a replaceable coil separately, or the entire affected pod or tank if the coil is fixed.
Reduced flavour or aerosol may be due to deposits and wear, but also to liquid level, battery or connection. These causes need to be distinguished before replacement. The guide on troubleshooting a burnt taste describes more possible causes.
Is dry heating harmful?
Overheating during a dry hit can produce higher levels of harmful substances in the aerosol. Do not take more puffs to see whether the burnt taste disappears.
A replacement coil for e-cigarettes must fit the tank or pod. The e-liquid must also suit the design’s liquid feeding.
Quick Facts
- Reading Time
- 3 min
- Popularity
- Very Popular
- Category
- Troubleshooting & maintenance
- Published
- 2025-05-09
Related Products
Products mentioned in this article





