
Stop using it if the e-cigarette tastes burnt. Dry or burnt cotton, buildup and excessive power can affect the taste. If the cotton has burnt, the coil needs to be replaced; with a pod with a fixed coil, the entire pod must be replaced.
Why does it taste burnt?
A low liquid level and insufficient wicking can leave the cotton dry. Excessive power consumes liquid faster than the wick can supply new liquid. Sucralose and other sweeteners can leave buildup; however, a sweet taste does not indicate which sweetener the liquid contains.
The coil's lifespan is affected by power, liquid and usage. A changed taste does not always mean that the cotton is burnt.
How do you prepare a new coil or pod?
Priming means allowing the cotton to absorb e-liquid before heating. With a replaceable coil with accessible cotton, liquid can be applied to the cotton openings before installation. Keep the liquid away from the central airflow channel.
For Innokin Ajax, the manufacturer specifies one drop on each visible cotton section on the side. Install the coil, fill the tank, close it and wait at least five minutes. The image illustrates priming a coil with accessible cotton.

A new refillable pod is filled through the filling port, closed and left without activation while the cotton absorbs the liquid. For the Innokin MVP pod, at least five minutes is specified. The waiting time depends on the model; the crucial point is that the cotton is thoroughly saturated before heating.
Do not open prefilled, sealed pods. Do not pull forcefully or repeatedly through the mouthpiece to prime it: a device with auto-draw may start heating. In MTL systems, the coil may be fixed or replaceable. MTL and DTL describe inhalation methods, not how the coil is installed.
What fill level, wattage and liquid are needed?
Fill through the correct port up to the maximum level and keep liquid away from the airflow channel. Refill before the level drops below the coil's liquid openings.
With adjustable power, use the coil's recommended range. If the coil is marked 20–30 W, start using it at 20 W after priming. A device with automatic power sometimes has no wattage control. Higher power or continued use does not repair burnt cotton.
PG is thinner than VG. Liquid that is too viscous may be supplied too slowly through small openings. For Vaporesso COSS, PG/VG 50:50 or a higher PG ratio is specified. This is a specification for COSS; otherwise, the blend needs to be matched to the specific design.
For help with the model and coil, contact support@cigge.se. Also see coils and the glossary of vape terms.
More guides on maintenance
Tips for avoiding burnt coils covers preventive maintenance. Also read about storing e-juice, steeping and leaking tanks.
Quick Facts
- Reading Time
- 3 min
- Popularity
- Very Popular
- Category
- Troubleshooting & maintenance
- Published
- 2022-12-22
Related Products
Products mentioned in this article





