A burnt taste can occur when the coil’s cotton is too dry or has been damaged by heating. The correct liquid level, power and priming reduce the risk of dry cotton. If the cotton has already burnt, the coil needs to be replaced; refilling or cleaning will not restore it.
A coil is the heating component in the e-cigarette. In a coil with cotton, the cotton transports e-liquid to the heating element, where the liquid is vaporized.
Tip 1 – Keep the liquid level above the coil’s liquid openings
Refill before the level becomes so low that the liquid cannot reach the coil’s cotton openings. Do not activate the e-cigarette with an empty tank or pod. When the cotton does not receive enough liquid, it can be damaged by the heat and produce a burnt taste.
The tank does not need to be kept full all the time. What matters is the liquid supply to the coil, and the tank must not be filled above its maximum level. Dry or damaged cotton can affect both the taste and the coil’s lifespan.
Tip 2 – Follow the coil’s recommended wattage range
Keep the power within the range specified by the manufacturer for the coil. Excessive power can vaporize the liquid faster than the cotton can absorb new liquid. Too little power can instead result in incomplete vaporization, spitting or leakage. Running below the range is therefore not a general method for extending lifespan.
A concrete example is Innokin’s 0.35-ohm Ajax coil: the manufacturer specifies 30–55 W and 30 W as the starting point. The power setting affects vaporization and therefore the amount of aerosol and how the taste is experienced.
Our explanation of wattage and power describes how the setting works.
Tip 3 – Let the cotton absorb new liquid between puffs
Avoid several frequent activations without a pause. The cotton needs time to absorb new liquid between uses. Otherwise, it can become dry while heat builds up. Stop using the device if the coil produces a burnt taste; continued heating will not restore burnt cotton.
Tip 4 – Match the e-liquid to the coil
PG (propylene glycol) is thinner than VG (vegetable glycerin), and the mixture affects how the liquid reaches the cotton. High PG is not a general solution for all coils: the liquid needs to suit the construction. Liquid that is too thick can make liquid feeding more difficult, while liquid that is too thin can contribute to leakage in a construction not designed for it.
For Vaporesso COSS, the manufacturer specifies PG/VG 50:50 or a higher PG ratio.
Sweeteners can leave deposits on the coil, impair liquid absorption and produce a burnt taste. Flavor names such as “Bakery” or dessert do not indicate the amount of sweetener in the liquid.
Tip 5 – Prime a new coil before heating it
Priming means moistening the cotton with e-liquid before heating. On a replaceable coil with accessible cotton openings, a small amount of liquid can be applied directly to the cotton before installation. Then fill the tank and let the cotton absorb the liquid before activating the device.
For the Innokin Proton Mini with Ajax tank, the manufacturer specifies one drop on each cotton opening on the side of the coil and waiting at least five minutes after filling. Liquid should not be dripped into the central airflow channel.
On a refillable pod with a built-in coil, the liquid is filled through the designated filling opening. Prefilled, sealed pods and disposable cartridges should not be opened for priming. Do not pull on the mouthpiece to speed up priming. On a model with auto-draw, such as the Aspire BP Stik, this can start heating before the cotton has become fully saturated.
If the burnt taste remains despite sufficient liquid and the correct power, a damaged coil needs to be replaced. In a pod with a built-in coil, the entire pod is replaced. Coils also wear out with correct use; there is no fixed lifespan that applies to all models and liquids.
More about nicotine and technology
Nicotine content is stated in mg/ml: 12 and 18 mg/ml respectively mean 12 and 18 mg of nicotine per milliliter. Nicotine is addictive. The amount delivered is also affected by power, liquid flow and puff duration; the battery’s mAh is its charging capacity. Our FAQ provides additional information about e-cigarettes and nicotine.
Customer comment from 2022
1 Comment #1 Cecilie Kjölner Thank you for a very good and clear explanation of how e-cigarettes work and for all the great tips 😊2022-06-25 @ 15:29:24
Quick Facts
- Reading Time
- 4 min
- Popularity
- Very Popular
- Category
- Troubleshooting & maintenance
- Published
- 2018-05-08
Related Products
Products mentioned in this article





