Troubleshooting & maintenance

5 Signs That Your Coil Needs Replacing

  • 2020-12-11
  • Author: daniel west
  • Updated: 2026-10-19
  • 5 min read
  • Very Popular(1160)
5 Signs That Your Coil Needs Replacing

A burnt taste, weaker flavour and less aerosol can be signs that the coil needs replacing. Bubbling sounds and leaks can also be caused by excess liquid, incorrect assembly or problems during refilling. Stop using the device if you experience a burnt taste.

1. Burnt taste

A burnt taste can be caused by dry or burnt cotton, but also by residue on the coil. Stop using the device if you experience a burnt taste. Burnt cotton needs to be replaced and cannot be restored by refilling or cleaning. Replace the coil if it is replaceable; with a fixed coil, replace the affected pod or tank.

A low liquid level, insufficient saturation or excessive power can make the cotton dry. A liquid with a high VG content, vegetable glycerin, may be absorbed too slowly if it is too viscous for the coil’s liquid openings. Higher wattage will not solve the problem and can make the cotton drier. Use liquid suited to the design and keep the power within the coil’s specified range.

More about causes and measures can be found in the troubleshooting guide for burnt taste.

2. Bubbling or gurgling sounds

Gurgling or wet bubbling may be caused by the coil being fed too much liquid or by liquid and condensation collecting in the airflow. A slight crackling sound during heating, however, can be normal and is not in itself a reason to replace the coil.

Turn off the device and let it cool. Wipe away visible liquid and condensation from the removable mouthpiece and accessible airways. Do not open a sealed pod. Do not fill above the maximum level and close the filling port properly. If the problem recurs despite correct assembly and intact seals, the coil may be damaged or worn and need replacing.

3. Weaker or changed flavour

A flavour that has become weaker or changed with the same liquid and settings may be caused by wear or residue on the coil. If the change persists despite proper liquid supply and power, the coil may need replacing.

Sweeteners such as sucralose can leave residue on the heating surface and contribute to buildup. The buildup is affected by the liquid’s contents, power and usage. A burnt taste should be handled as described in point 1, without continuing to use the coil to see if the flavour disappears.

4. Less aerosol

Less aerosol, often called vapour, may be caused by a worn coil, but also by a low battery level, too little liquid, a blocked airflow or a poor connection. Reduced flavour and aerosol can occur at the same time, but alone they do not provide a certain diagnosis.

Turn off the device and let it cool. On a refillable container, the liquid level should not fall below the coil’s liquid openings. Wipe accessible contacts dry and reinsert the removable pod or tank properly. Charge an undamaged, dry and cool rechargeable device with the intended charging equipment if the battery is low. On a device with a power setting, the power should be within the coil’s specified range. If both flavour and aerosol have decreased with a used coil despite sufficient liquid, a charged battery and a proper connection, the coil may need replacing.

5. Leakage through the airflow

Leakage from the airflow may be caused by an overfed coil, incorrect assembly, overfilling or leaky components. Liquid can then pass through the coil into the airflow. Replacing the coil will not help if the cause is a damaged seal or an improperly closed filling cap.

Turn off the device and wipe away any leaked liquid. Fit the replaceable coil fully into place, assemble threaded parts straight and close the filling cap or silicone plug properly. Do not fill above the maximum level. Replace damaged, replaceable seals with suitable spare parts and do not use force on a jammed thread. If the leakage continues despite correct assembly and intact seals, the coil may be defective and need replacing. With a fixed coil, replace the affected pod or tank.

For the Innokin GoMax, the manufacturer states that the airflow ports should be closed during filling and opened again afterwards.

If liquid has reached the electronics, stop using and charging the device. Contact our support. More causes and measures can be found in the troubleshooting guide for leakage.

When should the coil be replaced?

Replace a coil with burnt cotton. For other symptoms, the cause should be determined using the checks in the points above.

Service life is affected by e-liquid, power, liquid supply and usage. There is no replacement interval that applies to all coils. When replacing the coil, it must fit the pod or tank and be saturated before use. The steps are described in the guide on how to replace a coil.

Questions about coils can be sent to our support via Mail - support@cigge.se.

Quick Facts

Reading Time
5 min
Popularity
Very Popular
Category
Troubleshooting & maintenance
Published
2020-12-11

Related Products

Products mentioned in this article