
The airflow control changes the air opening and draw resistance. A larger opening makes the draw more open, while a smaller one makes it tighter. The amount of air also affects heating and aerosol together with the coil and power.
What is airflow on an e-cigarette?
Airflow is the air that passes through the device during a puff. Some models have a fixed air intake, while others have a dedicated control. The Innokin GoMax has a rotating ring at the bottom of the tank. The original Innokin Sceptre has a sliding control on the pod.
What happens when the air opening is changed?
- Larger opening: less draw resistance. More air can contribute to cooling during use.
- Smaller opening: greater draw resistance and less air. Limited airflow can produce more heat at a given power level.
Temperature and the amount of aerosol are also affected by the coil's construction and power. The control therefore does not provide a specific temperature.
What distinguishes MTL from DTL?
MTL, mouth-to-lung, means that the aerosol is first drawn into the mouth and then into the lungs, an order that also occurs when smoking cigarettes. MTL designs often have tighter airflow and lower power.
DTL, direct-to-lung, means direct inhalation into the lungs. DTL designs often have larger air intakes and higher power and can produce more aerosol. The airflow control changes the draw resistance within the design; it does not change the device type or the liquid's nicotine content.
How is the control adjusted?
- Turn off the device and let it cool. On the GoMax, use the ring at the bottom of the tank; on the original Sceptre, use the pod's sliding control.
- Move the control within its range of motion without tools or force. Keep the air intakes clear and do not use the device with the airflow completely closed.
- Keep the intended coil and power setting. Stop if there is a burnt taste or abnormal heat instead of continuing to test settings.
What should I do in case of weak flavor, heat, or a blocked airflow?
Weak flavor may be caused by the liquid, the condition of the coil, and the power. A smaller air opening is not a general solution. In case of abnormal heat, stop using the device; opening the control does not repair the fault.
Wipe accessible condensation from switched-off equipment and keep the intended air openings clear. Do not drill out or block fixed openings. Do not open the electronics or a sealed pod. In case of damage or suspected liquid in the electronics, stop both use and charging.
Is battery consumption affected?
The airflow control is not a power control. Energy consumption is affected by power and heating time. A DTL design with higher power can use more energy per second than a design with lower power.
Does the same setting suit all e-liquids?
The liquid needs to suit the coil's feed openings and wick. The airflow control does not make a liquid that is too viscous easier to feed. Innokin specifies 50VG/50PG or 70VG/30PG for Go-Z and at least 70 percent VG for GoMax. VG and PG in e-liquid explains the mixtures.
Quick Facts
- Reading Time
- 3 min
- Popularity
- Very Popular
- Category
- Vape
- Published
- 2025-08-13
Related Products
Products mentioned in this article

Vaporesso Vibe Pod Vape Kit
159,90 kr
View Product
Vaporesso XROS Cartridge Pods (4-Pack, Mesh)
149,90 kr
View Product
Oxva Xlim GO 2 Pod Vape Kit
159,90 kr
View Product
Vaporesso XROS 6 Pod Kit
319,90 kr
View Product
Vaporesso VIBE Smart Pods 3-pack
119,90 kr
View Product
OXVA Xlim Pro 3 Pod Vape Kit
349,90 kr
View Product