Vape

OXVA XLIM SE and XLIM V2 – Model Comparison from 2022

  • 2022-09-09
  • Author: daniel west
  • Updated: 2026-10-23
  • 3 min read
  • Very Popular(1049)
OXVA XLIM SE and XLIM V2 – Model Comparison from 2022

In September 2022, OXVA XLIM SE and XLIM V2 were part of our range of starter kits. Both were compact, refillable pod systems with a built-in 900 mAh battery. XLIM V2 had a display and manual power adjustment, while XLIM SE selected the power automatically. Both had adjustable airflow.

What distinguished XLIM V2 from XLIM SE?

XLIM V2 could be activated with a button or by drawing on the mouthpiece. The same button was used to set the power. XLIM SE was activated only by drawing and had neither a button nor a display. On both models, the airflow was adjusted with a separate control on the side.

FeatureXLIM V2XLIM SE
Built-in battery900 mAh900 mAh
Pod capacity2 ml2 ml
PowerAdjustable, 5–25 WAutomatically selected, within 5–25 W
ActivationButton or drawDraw
Information display0.42-inch OLED screen with battery level, power and puff counterLED light showing battery status
AirflowAdjustable side controlAdjustable side control
ChargingUSB-C, 5 V/1 AUSB-C, 5 V/1 A

Which pods and e-liquids were used?

Both models used OXVA XLIM V2 pods with side filling and a built-in coil. They were available with resistances of 0.6, 0.8 and 1.2 ohms. When the coil was used up, the entire pod was replaced.

The models could be used for MTL, mouth-to-lung, where the vapour is first drawn into the mouth and then down into the lungs. The airflow could be opened or restricted with the side control. OXVA stated support for e-liquid with freebase nicotine and nicotine salt.

For the V2 pods, OXVA specified 20–25 W for 0.6 ohms, 12–16 W for 0.8 ohms and 10–12 W for 1.2 ohms. On XLIM SE, the power selection was handled automatically.

How was the pod filled and when did it need to be replaced?

The V2 pod was filled through the opening on the side. Close the silicone plug firmly after filling. The design was intended to limit leakage and condensation under the pod.

After the first filling of a new pod, the XLIM manual specified a waiting time of 5–8 minutes to allow the wick to absorb the liquid. Do not use the pod when it is empty. If there is a burnt taste, stop using it; a pod with a burnt wick needs to be replaced.

A weaker flavour or less vapour may be signs that the pod is used up. A low liquid level or a battery that needs charging may also affect use.

How was the battery charged?

Both models were charged via USB-C with a specified charge of 5 V/1 A. Use an undamaged cable and a suitable USB power source. Charge under supervision and disconnect the device when it is fully charged. Do not use or charge a device that is damaged or becomes abnormally hot.

Nicotine is addictive. Keep e-liquid and the device out of reach of children and avoid skin contact with e-liquid. The sale of e-cigarettes and nicotine-containing e-liquid is restricted to those aged 18 and over.

Our current range can be found among rechargeable starter kits and e-cigarettes.

Quick Facts

Reading Time
3 min
Popularity
Very Popular
Category
Vape
Published
2022-09-09

Related Products

Products mentioned in this article